GO
Washer/Dryer Combo

Maytag Washer/Dryer Combo Parts (502 results)

Refine Selection Here:

Product Type

  • Washer/Dryer Combo

Model Number

Part Category

Part Title

Maytag Washer/Dryer Combo Thermistor

Item # 1181075

Grid is 1 inch square
Thermistor - Part # 1181075 Mfg Part # WP8577274

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

OEM Part - Manufacturer #WP8577274

$57.31

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Moisture Sensor

Item # 525385

Grid is 1 inch square
Moisture Sensor - Part # 525385 Mfg Part # WP3387223

Dryer moisture sensor bar. This moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dry. If your moisture sensor is defective, the dryer may shut off too early or continue running for a while after the clothes are dry. Two required.

OEM Part - Manufacturer #WP3387223

$12.27

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Suspension Spring

Item # 671098

Grid is 1 inch square
Suspension Spring - Part # 671098 Mfg Part # WP63907

Washing machine suspension spring. If the suspension spring is broken, the washer will be off balance.

OEM Part - Manufacturer #WP63907

$9.38

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Thermal Fuse

Item # 897710

Grid is 1 inch square
Thermal Fuse - Part # 897710 Mfg Part # 279973

Dryer high limit thermostat and thermal fuse kit. If the dryer does not heat the most common cause is a blown thermal fuse. Both the thermostat and fuse can be tested to determine if either is defective.352 F fuse. L146.1-44.4c thermostat.

OEM Part - Manufacturer #279973

$62.79

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Blower Wheel

Item # 1245880

Grid is 1 inch square
Blower Wheel - Part # 1245880 Mfg Part # Y303836

Dryer blower wheel for exhaust with clamp. If the dryer does not heat properly then this wheel may be stripped causing an air flow problem.

OEM Part - Manufacturer #Y303836

$33.51

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Drum Slide, Glide, or Pad

Item # 1309

Grid is 1 inch square
Drum Slide, Glide, or Pad - Part # 1309 Mfg Part # 306508

Dryer front drum support glide. Order 2 when repairing the dryer. Be aware it requires a rivet tool to install the new glide and the tool must be purchased locally.

OEM Part - Manufacturer #306508

$22.68

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Drum Roller Axle

Item # 1480353

Grid is 1 inch square
Drum Roller Axle - Part # 1480353 Mfg Part # WP6-3129480

Dryer drum roller axle. If the dryer is noisy this roller axle or the roller itself may be worn and require replacement.

OEM Part - Manufacturer #WP6-3129480

$13.75

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Touch-Up Paint

Item # 185

Grid is 1 inch square
Touch-Up Paint - Part # 185 Mfg Part # 72017

White touch-up paint. .6 oz.

OEM Part - Manufacturer #72017

Hazardous Material – Special Shipping Required

$9.72

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Idler Pulley

Item # 2958

Grid is 1 inch square
Idler Pulley - Part # 2958 Mfg Part # 279640

Dryer idler pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.

OEM Part - Manufacturer #279640

$35.62

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Lint Filter

Item # 3452

Grid is 1 inch square
Lint Filter - Part # 3452 Mfg Part # WP33001003

Dryer slide in lint filter (lint trap). Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.

OEM Part - Manufacturer #WP33001003

$26.64

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Belt Kit

Item # 402507

Grid is 1 inch square
Belt Kit - Part # 402507 Mfg Part # 12112425

Washer belt kit for Maytag models. If the washer does not agitate, spin, or drain then one of the belts could be worn and require replacement. Belt sizes: 41 in x 5/16 in, 42-1/3in by 7/16 in

OEM Part - Manufacturer #12112425

$54.40

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo High Temperature Adhesive

Item # 1243096

Grid is 1 inch square
High Temperature Adhesive - Part # 1243096 Mfg Part # WPY055980

High temperature adhesive for installing rubber feet and felt seals, 2 ounces.

OEM Part - Manufacturer #WPY055980

Hazardous Material – Special Shipping Required

$30.27

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Transmission

Item # 423

Grid is 1 inch square
Transmission - Part # 423 Mfg Part # 3360629

Transmission (gearbox) for direct-drive washing machines. If the gears inside the transmission are worn out, the washer may not spin.

OEM Part - Manufacturer #3360629

Special Shipping Required

$329.41

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Lint Filter

Item # 1394

Grid is 1 inch square
Lint Filter - Part # 1394 Mfg Part # WP33001808

Dryer lint filter. This filter should be cleaned before every load to ensure proper airflow for dryer operation. If the lint filter is ripped or torn, replace it.

OEM Part - Manufacturer #WP33001808

$57.02

Order now and this item will ship out tomorrow

Add to Cart

Maytag Washer/Dryer Combo Thermal Fuse

Item # 2821

Grid is 1 inch square
Thermal Fuse - Part # 2821 Mfg Part # 279769

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.

OEM Part - Manufacturer #279769

$49.30

Order now and this item will ship out tomorrow

Add to Cart

502 results