- 1-844-200-5438
- My Orders
- Cart 0 item(s)
Refine Selection Here:
Item # 2986
Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.
OEM Part - Manufacturer #WP3392519
Item # 1890433
Microwave incandescent light bulb, 40 Watt. Comes with small screw in base. If the light bulb threads are corroded, or the bulb base is too large, the socket may also need to be replaced.
OEM Part - Manufacturer #8206232A
Item # 529597
Dryer drum drive belt. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves. If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.
OEM Part - Manufacturer #341241
Item # 1925071
Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.
OEM Part - Manufacturer #WPW10314173
Item # 2438
Dryer heating element. If your dryer does not heat first check for a blown thermal fuse on the blower housing before replacing the heating element. In most cases the heating element will have a break in the element if defective. *May need wire connector to install heating element.
OEM Part - Manufacturer #279838
Item # 1958
40 Watt frosted appliance light bulb.
OEM Part - Manufacturer #8009
Item # 1481881
Chrome drip bowl (also called a drip pan) for 8 inch burner on an electric range. The drip pan sits underneath the heating element to collect drips or spills around the burner.
OEM Part - Manufacturer #WPW10196405
Item # 587636
Repair kit for Whirlpool, Kenmore, Roper dryer; rollers, belt and idler pulley, for 29" wide Dryers built 1965 and later. This dryer maintenance kit contains all of the parts that are commonly defective when the dryer is noisy.
-Call with model# to verify if kit is compatible with your dryer.
OEM Part - Manufacturer #4392065
Item # 4380739
Door handle, white. Snaps in place
OEM Part - Manufacturer #W10861225
Item # 1471887
Chrome drip bowl for 6" burner, electric range. Will not fit Thermador, GE, Hotpoint or Jenn Air
OEM Part - Manufacturer #WPW10196406
Item # 2893
Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.
OEM Part - Manufacturer #WP3387134
Item # 4161369
Bake element assembly with support brackets
OEM Part - Manufacturer #W10779716
Item # 3346
Dryer belt tension idler pulley assembly.When the idler pulley goes bad it will usually make a high pitch squeeling or rattling noise.
OEM Part - Manufacturer #WP691366
Item # 2786
Surface element control switch (also called the infinite switch) for 8 inch element. The surface element switch sends voltage to the surface element coil. If the switch is defective, the surface element will not work.
OEM Part - Manufacturer #WP3149400
Item # 3377
Oven igniter kit. Can replace igniters for either bake or broil burners. Replaces shorter and longer igniters in many instances. Amperage range is 3.3 - 3.6. If the igniter glows for more than 90 seconds without igniting the gas flame, this indicates that the igniter is too weak to open the valve.
OEM Part - Manufacturer #12400035
