Dryer drum drive belt, 100 inches long, 3/8" wide,5 ribs 4 grooves. The drive belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

OEM Part - Manufacturer #WPY312959

Make sure the belt is aligned on the high part of the drum. If it is riding in the groove it will rub on the idler pulley guide arm.

Dryer blower wheel for exhaust with clamp. If the dryer does not heat properly then this wheel may be stripped causing an air flow problem.

OEM Part - Manufacturer #Y303836

Dryer front drum support glide. Order 2 when repairing the dryer. Be aware it requires a rivet tool to install the new glide and the tool must be purchased locally.

OEM Part - Manufacturer #306508

Consider replacing the drum support rollers while you have the dryer apart as they wear out over time.

Dryer drum roller axle. If the dryer is noisy this roller axle or the roller itself may be worn and require replacement.

OEM Part - Manufacturer #WP6-3129480

Dryer slide in lint filter (lint trap). Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.

OEM Part - Manufacturer #WP33001003

Washer belt kit for Maytag models. If the washer does not agitate, spin, or drain then one of the belts could be worn and require replacement. Belt sizes: 41 in x 5/16 in, 42-1/3in by 7/16 in

OEM Part - Manufacturer #12112425

High temperature adhesive for installing rubber feet and felt seals, 2 ounces.

OEM Part - Manufacturer #WPY055980

White silicone adhesive caulk. Forms a heat resistant bond. Often used for gaskets, seals and burner grate feet.

OEM Part - Manufacturer #W10841140

Dryer idley pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.

OEM Part - Manufacturer #WP6-3037050

Dryer door catch kit. Includes door catch and clip (plastic)

OEM Part - Manufacturer #306436

Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.

OEM Part - Manufacturer #W10169313

Drum seal (front or rear) . 79 inches.

OEM Part - Manufacturer #WP314820

Some dryers have this seal secured with metal tabs while others require the recommended High Temperature Adhesive below. Best to check out the seal before ordering.

6 Foot fill hose, one straight & one elbow, requires 2 washers

OEM Part - Manufacturer #WP76314

Replace inlet hoses after 5 years of use to reduce the risk of hose failure.