- 1-844-200-5438
- My Orders
- Cart 0 item(s)
Refine Selection Here:
Item # 2958
Dryer idler pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.
OEM Part - Manufacturer #279640
Item # 3018
Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.
OEM Part - Manufacturer #4391996
Item # 3452
Dryer slide in lint filter (lint trap). Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.
OEM Part - Manufacturer #WP33001003
Item # 1549326
Washing machine tub counterbalance spring. This spring offsets the weight of the motor on the front of the washer. If broke, the tub will lean forward and the tub will be off balance during the spin cycle.
OEM Part - Manufacturer #WPW10250667
Item # 1243096
High temperature adhesive for installing rubber feet and felt seals, 2 ounces.
OEM Part - Manufacturer #WPY055980
Item # 1394
Dryer lint filter. This filter should be cleaned before every load to ensure proper airflow for dryer operation. If the lint filter is ripped or torn, replace it.
OEM Part - Manufacturer #WP33001808
Item # 2821
Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.
OEM Part - Manufacturer #279769
Item # 2681
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
OEM Part - Manufacturer #WP338906
Item # 4281917
Washing machine drain pump. *Coin trap only available with pump assembly. If the washer does not drain the pump could be locked up or a small object may be clogging it. Also a small leak in front of the washer could be caused by a defective pump.
OEM Part - Manufacturer #WPW10730972
Item # 539455
Washer agitator bolt with rubber gasket and thread sealant. Head is 7/16 inches in diameter.
OEM Part - Manufacturer #WP358237
Item # 455007
Light bulb, 10 watt. Small screw in base
OEM Part - Manufacturer #WP22002263
Item # 3140
Heating element wire connector kit for electric dryers. If the wire & connector at the dryer heating element is bad this wire connector kit can be used to repair it.
OEM Part - Manufacturer #279457
Item # 1558
Timer dial skirt. Knob and cap are sold seperately
OEM Part - Manufacturer #WP33001621
Item # 4248250
Washing machine main tub seal
OEM Part - Manufacturer #W10814296
