Maytag MDE10PDEGL Dryer Replacement Parts

Dryer drum drive belt, 100 inches long, 3/8" wide,5 ribs 4 grooves. The drive belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Make sure the belt is aligned on the high part of the drum. If it is riding in the groove it will rub on the idler pulley guide arm.

Snap retaining ring

Dryer blower wheel for exhaust with clamp. If the dryer does not heat properly then this wheel may be stripped causing an air flow problem.

Dryer drum bearing slide kit

Consider replacing the drum support rollers while you have the dryer apart as they wear out over time.

Dryer idley pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.

Screw, 10-24 3/8

Dryer door latch & catch kit

Felt seal

Some dryers have this seal secured with metal tabs while others require the recommended High Temperature Adhesive below. Best to check out the seal before ordering.

Door catch kit, includes catch and clip (metal) Replace both parts for best results

Spring clamp for blower wheel

Thermal fuse

To determine if your thermal fuse is defective, use a multimeter to test it for continuity.

Rubber leveling leg foot.

High-limit thermostat L200-30