Maytag GDG27CS Dryer Replacement Parts

Dryer drum drive belt, 100 inches long, 3/8" wide,5 ribs 4 grooves. The drive belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Make sure the belt is aligned on the high part of the drum. If it is riding in the groove it will rub on the idler pulley guide arm.

Snap retaining ring

Dryer blower wheel for exhaust with clamp. If the dryer does not heat properly then this wheel may be stripped causing an air flow problem.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer drum bearing slide kit

Consider replacing the drum support rollers while you have the dryer apart as they wear out over time.

Self-tapping screw.

Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

Dryer idley pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.

Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.

Screw, 10-24 3/8

Dryer door latch & catch kit

Adjustable leveling leg

Felt seal

Some dryers have this seal secured with metal tabs while others require the recommended High Temperature Adhesive below. Best to check out the seal before ordering.