Maytag MEDB200VQ0 Dryer Replacement Parts

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

Dryness sensor bar

Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.

Plastic leveling leg. White approximately 1" round x 1 3/4" long

Dryer heating element. If the dryer no longer heats then the heating element may have failed, but it is not the most common cause. The most common cause for a dryer to stop heating is a blown thermal fuse.

Dryer tri-ring retainer for drum support rollers.

Dryer heating element wire connector kit. Wire with spade terminal & wire nut

Light Bulb 10 Watt small base

Dryer idler wheel and bracket assembly. Provides tension to the dryer drum belt.

Dryer door catch. If the dryer door does not latch closed then the door strike or this catch is likely damaged

White Touch Up Paint

Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.

Thermal cut out fuse and high limit thermostat kit