Maytag PYG2300AGW Dryer Replacement Parts

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Snap retaining ring

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Screw, 10-24 3/8

Dryer thermal fuse and high limit thermostat kit for both gas and electric models. If the dryer does not heat then the thermal fuse may have blown and will need to be replaced.

The thermal fuse often blows when the exhaust vent gets clogged with lint. The vent should be cleaned once a year especially if it is longer than 15 feet.

Dryer lint filter (lint trap). Your lint filter should be replaced if it is torn or damaged in any way.

Dryer blower wheel, 3-1/8" deep, 8" in diameter, 7-1/8" hub diameter, 20 standard fins, ½" diameter motor shaft, 3/8" motor shaft diameter to flat side of shaft. If more than one blower wheel is listed with your model, call us with your model and serial number to verify the part.

Door catch kit, includes catch and clip (metal) Replace both parts for best results

Screw

Spring clamp for blower wheel

Screw & Washer

Drum glide kit, right side. *Pad has adhesive backing

Fine thread hex head screw