Maytag MDG9520BWW Dryer Replacement Parts

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Dryer drum drive belt

While the dryer is apart consider replacing the idler pulley when installing a new belt.

Snap retaining ring

Light Bulb 10 Watt small base

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer drum bearing slide kit

Consider replacing the drum support rollers while you have the dryer apart as they wear out over time.

Idler pulley wheel and bearing. If the idler pulley wheel and/or bearing is defective, it may cause the dryer to be excessively noisy.

Lint filter assembly

This is a genuine replacement part. Whirlpool 33001621 Knob Skirt.

Order a new knob base and cap to get all the parts for the timer knob assembly.

Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

Drum baffle, tall

Drum felt seal

You must use high-temperature adhesive to install the seal.

Screw, 10-24 3/8