Maytag Dryer Model MGD5630HC3 Parts

Dryer idler pulley assembly. Includes bracket and attached pulley

OEM Part - Manufacturer #W10837240

Consider replacing the belt while the dryer is apart.

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

OEM Part - Manufacturer #WPW10314173

The drum support roller kit, 349241T. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

OEM Part - Manufacturer #349241T

The drum rollers and drum roller axles often wear out at the same time. If the drum roller axles are worn out, replace them along with the drum rollers.

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

OEM Part - Manufacturer #661570V

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

OEM Part - Manufacturer #279834

The Whirlpool Burner Igniter Kit 279311 is a high-quality replacement part that ignites gas to light the dryer burner. It replaces multiple igniters and requires safety precautions and disconnection from utilities before installation.

OEM Part - Manufacturer #279311

Consider replacing the gas valve coils while you have the dryer apart.

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

OEM Part - Manufacturer #WP8577274

Dryer tri-ring retainer for drum support rollers.

OEM Part - Manufacturer #WPW10512946

Motor pulley, 60 hertz

OEM Part - Manufacturer #WP8066184

Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.

OEM Part - Manufacturer #W10909685

The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.

OEM Part - Manufacturer #WP697772

Dryer drum felt seal kit. Includes silicone rubber adhesive.

OEM Part - Manufacturer #280114

This is a genuine replacement part. The model number and name for the following item is: Whirlpool 279787 Drive Motor.

OEM Part - Manufacturer #279787