Maytag MGD6230HC3 Dryer Replacement Parts

The Dryer Maintenance Kit 4392067 includes drum support rollers, a multi-rib belt, an idler pulley wheel, triangle clips, and a washer for a complete maintenance overhaul. If your Whirlpool, Kenmore, or Maytag dryer is making loud noises or the drum is not turning, it may be time for replacement.

Dryer idler pulley assembly. Includes bracket and pulley wheel

Consider replacing the belt while the dryer is apart.

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

The dryer belt wears out over time. Consider replacing the belt while the dryer is apart.

The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.

Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.

White Touch Up Paint

Dryer LP conversion kit; Natural gas to LP (liquid propane). This kit includes the orifice, leak limiter, and instruction sheet.

Cleaning brush for refrigerators, freezers, dryers and more. This brush is perfect for cleaning condenser coils on refrigeration systems. It is important to regularly clean the condenser coil to ensure the refrigerator is running efficiently.

Pair this tool with this vacuum extension tube and easily clean under appliances without having to move them.

Dryer vent testing kit is for 29" dryers with a top mounted lint screen. Use the plastic card to hang inside your dryer drum, then run the unit three times empty. If the card stays in place, the venting and dryer need to be cleaned out. Complete instructions are included.

Plastic card that you hang inside your dryer drum (complete instructions are included), then run it 3 times, empty. If card stays in place venting and dryer need to be cleaned out.

Door switch assembly

Spray Paint - White

Dryer leveling leg set of 4