Maytag 4KMEDC410JW0 Dryer Replacement Parts

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

A bad fuse will have no continuity meaning the electrical path is broken. A multimeter can be used to test it for continuity.

Door handle, white. Snaps in place

Dryer high-limit thermostat, L250-80, with terminal extension arm. This thermostat should be closed for continuity at room temperature and opens at around 250 degrees Fahrenheit. If the dryer won't heat, the high-limit thermostat might be defective.

The part may look different than the original but the part will still install and work the same.

Door catch

Dryer lint screen assembly. Proper air flow is critical to dryer operation so the filter should be cleaned before every load.

Idler pulley for dryer drum drive belt

Consider replacing the Drive Belt while you have the dryer apart.

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

Dryer tri-ring retainer for drum support rollers.

Dryer heating element wire connector kit. Wire with spade terminal & wire nut

Timer knob, white

Lint screen housing foam seal

Screw, 10-24 x 1/2

Dryer blower housing foam seal with adhesive backing. 26 in