Maytag 7MMEDC300DW1 Dryer Replacement Parts

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

A bad fuse will have no continuity meaning the electrical path is broken. A multimeter can be used to test it for continuity.

Dryer electric heating element assembly

The heating element and many other parts can be tested using a volt/ohm meter which is a handy item to have in any do it yourselfers tool box.

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

Door handle, white. Snaps in place

Dryer high-limit thermostat, L250-80, with terminal extension arm. This thermostat should be closed for continuity at room temperature and opens at around 250 degrees Fahrenheit. If the dryer won't heat, the high-limit thermostat might be defective.

The part may look different than the original but the part will still install and work the same.

Door catch

Dryer lint screen assembly. Proper air flow is critical to dryer operation so the filter should be cleaned before every load.

Idler pulley for dryer drum drive belt

Consider replacing the Drive Belt while you have the dryer apart.

Dryer drum drive motor with pulley

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

Dryer drum rear felt seal kit with adhesive.

Dryer tri-ring retainer for drum support rollers.