Maytag MGDC300BW0 Dryer Replacement Parts

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

A bad fuse will have no continuity meaning the electrical path is broken. A multimeter can be used to test it for continuity.

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

The Whirlpool Dryer Cycling Thermostat WP3387134, rated at L155-25, regulates the temperature within your dryer. Signs that the thermostat needs replacement include inconsistent drying temperatures or the dryer running excessively hot. The WP3387134 is compatible with various dryer models.

Dryer lint screen assembly. Proper air flow is critical to dryer operation so the filter should be cleaned before every load.

The Whirlpool Burner Igniter Kit 279311 is a high-quality replacement part that ignites gas to light the dryer burner. It replaces multiple igniters and requires safety precautions and disconnection from utilities before installation.

Consider replacing the gas valve coils while you have the dryer apart.

Dryer drum drive motor with pulley

Idler pulley for dryer drum drive belt

Consider replacing the Drive Belt while you have the dryer apart.

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

Dryer drum rear felt seal kit with adhesive.

Motor pulley, 60 hertz

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.