Maytag MDG6460AWW Washer/Dryer Combo Replacement Parts

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Dryer drum drive belt

While the dryer is apart consider replacing the idler pulley when installing a new belt.

Idler pulley wheel and bearing. If the idler pulley wheel and/or bearing is defective, it may cause the dryer to be excessively noisy.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Light Bulb 10 Watt small base

Dryer drum bearing slide kit

Consider replacing the drum support rollers while you have the dryer apart as they wear out over time.

Lint filter assembly

Drum baffle, tall

Drum felt seal

You must use high-temperature adhesive to install the seal.

Screw, 10-24 3/8

Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.

Dryer door latch & catch kit

Drum baffle, short

For the tall drum baffle, order part 516891.