Maytag Dryer Model MDG3000AWW Parts

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

OEM Part - Manufacturer #279834

Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.

OEM Part - Manufacturer #WP3387134

Dryer drum drive belt

OEM Part - Manufacturer #WP33002535

While the dryer is apart consider replacing the idler pulley when installing a new belt.

Dryer drum roller axle. If the dryer is noisy this roller axle or the roller itself may be worn and require replacement.

OEM Part - Manufacturer #WP6-3129480

Dryer drum bearing slide kit

OEM Part - Manufacturer #306508

Consider replacing the drum support rollers while you have the dryer apart as they wear out over time.

Idler pulley wheel and bearing. If the idler pulley wheel and/or bearing is defective, it may cause the dryer to be excessively noisy.

OEM Part - Manufacturer #WP6-3700340

Snap retaining ring

OEM Part - Manufacturer #WP9703438

This is a genuine replacement part. The model number and name for the following item is: Whirlpool 33001808 Lint Filter.

OEM Part - Manufacturer #WP33001808

Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

OEM Part - Manufacturer #4391996

This is a genuine replacement part. The model number and name for the following item is: Whirlpool 22002263 Light Bulb.

OEM Part - Manufacturer #WP22002263

This is a genuine replacement part. The model number and name for the following item is: Whirlpool 33001621 Knob Skirt.

OEM Part - Manufacturer #WP33001621

Order a new knob base and cap to get all the parts for the timer knob assembly.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

OEM Part - Manufacturer #WP338906

This is a genuine replacement part. The model number and name for the following item is: Whirlpool 306436 Latch Kit.

OEM Part - Manufacturer #306436