Dryer heating element. If your dryer does not heat first check for a blown thermal fuse on the blower housing before replacing the heating element. In most cases the heating element will have a break in the element if defective. *May need wire connector to install heating element.

OEM Part - Manufacturer #279838

The heating element and many other parts can be tested using a volt/ohm meter which is a handy item to have in any do it yourselfers tool box.

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

OEM Part - Manufacturer #WPW10314173

Dryer heating element thermal cut-off (thermal fuse) 309 degrees and high limit thermostat 250 degrees, with wiring kit. If the dryer does not heat the thermal cut off may have blown and a new high limit thermostat is needed.

OEM Part - Manufacturer #279816

Door handle, white. Snaps in place

OEM Part - Manufacturer #W10861225

Dryer lint screen assembly. Proper air flow is critical to dryer operation so the filter should be cleaned before every load.

OEM Part - Manufacturer #WPW10717210

Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.

OEM Part - Manufacturer #WP3387134

Dryer belt tension idler pulley assembly.When the idler pulley goes bad it will usually make a high pitch squeeling or rattling noise.

OEM Part - Manufacturer #WP691366

Consider replacing the Drive Belt while you have the dryer apart.

Dryer drum drive motor. Includes pulley for dryer drum drive belt. Other shaft has reverse threads for blower wheel. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all
-Dryer drive motor is loud

OEM Part - Manufacturer #279827

Dryer high-limit thermostat, L250-80, with terminal extension arm. This thermostat should be closed for continuity at room temperature and opens at around 250 degrees Fahrenheit. If the dryer won't heat, the high-limit thermostat might be defective.

OEM Part - Manufacturer #WP3977767

The part may look different than the original but the part will still install and work the same.

Door catch

OEM Part - Manufacturer #WPW10610880

Dryer timer assembly

OEM Part - Manufacturer #WPW10185982

Plastic leveling leg. White approximately 1" round x 1 3/4" long

OEM Part - Manufacturer #49621

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

OEM Part - Manufacturer #WP694089