Maytag Washer/Dryer Combo Model LDG7304AGE Parts

Dryer drum drive belt, 100 inches long, 3/8" wide,5 ribs 4 grooves. The drive belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

OEM Part - Manufacturer #WPY312959

Make sure the belt is aligned on the high part of the drum. If it is riding in the groove it will rub on the idler pulley guide arm.

Dryer drum roller axle. If the dryer is noisy this roller axle or the roller itself may be worn and require replacement.

OEM Part - Manufacturer #WP6-3129480

Dryer blower wheel for exhaust with clamp. If the dryer does not heat properly then this wheel may be stripped causing an air flow problem.

OEM Part - Manufacturer #Y303836

Dryer drum bearing slide kit

OEM Part - Manufacturer #306508

Consider replacing the drum support rollers while you have the dryer apart as they wear out over time.

High temperature adhesive for installing rubber feet and felt seals, 2 ounces.

OEM Part - Manufacturer #WPY055980

Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

OEM Part - Manufacturer #4391996

Dryer idley pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.

OEM Part - Manufacturer #WP6-3037050

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

OEM Part - Manufacturer #WP338906

This is a genuine replacement part. The model number and name for the following item is: Whirlpool 306436 Latch Kit.

OEM Part - Manufacturer #306436

Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.

OEM Part - Manufacturer #W10169313

Screw, 10-24 3/8

OEM Part - Manufacturer #WP90767

This is a genuine replacement part. The model number and name for the following item is: Whirlpool 314820 Tumbler Seal.

OEM Part - Manufacturer #WP314820

Some dryers have this seal secured with metal tabs while others require the recommended High Temperature Adhesive below. Best to check out the seal before ordering.

Dryer high-limit thermostat, L220-40F. If the dryer overheats, this high-limit thermostat will cut off the power to the heating element. If the high-limit thermostat has blown, the dryer won't heat.

OEM Part - Manufacturer #WP303395