Maytag Washer/Dryer Combo Model MLE20PDAZW0 Parts

Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.

OEM Part - Manufacturer #WP3392519

A bad fuse will have no continuity meaning the electrical path is broken. A multimeter can be used to test it for continuity.

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

OEM Part - Manufacturer #WPW10314173

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

OEM Part - Manufacturer #279834

Dryer door catch kit. This kit includes three different door catches; you will need to select the door catch that fits your model.

OEM Part - Manufacturer #279570

Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.

OEM Part - Manufacturer #W10120998

Dryer igniter kit. This igniter will replace both round and flat style igniters. The kit includes the bracket, wire nuts and mounting screw. Be aware the igniter is very fragile and should be handled carefully.

OEM Part - Manufacturer #279311

Consider replacing the gas valve coils while you have the dryer apart.

Screw

OEM Part - Manufacturer #WP308685

Dryer tri-ring retainer for drum support rollers.

OEM Part - Manufacturer #WPW10512946

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

OEM Part - Manufacturer #WP8577274

Affresh® Washing machine cleaner. This cleaner removes and prevents odor-causing residue in all brands of washers. To use, add one tablet to washer with no clothes and select hot water.

- Septic safe
- More effective than bleach.
- Three tablets per package.

OEM Part - Manufacturer #W10135699

Affresh® Dishwasher Cleaner is specially formulated to help remove limescale and mineral build-up.

5-foot-long rubber fill hose for washing machines. Used for hot or cold water.

OEM Part - Manufacturer #WP89503

Over time, rubber hoses dry out and become susceptible to leaks or bursts. Replace fill hoses every 5 years to reduce the risk of hose failure.

Dryer high limit thermostat and thermal fuse kit. If the dryer does not heat the most common cause is a blown thermal fuse. Both the thermostat and fuse can be tested to determine if either is defective.

OEM Part - Manufacturer #279973

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

OEM Part - Manufacturer #WP338906

White touch-up paint. .6 oz.

OEM Part - Manufacturer #72017